An all in one radio replacement and SWC interface, the innovative RadioPRO5 comes pre-loaded with OnStar retention, amplifier retention, SWC software, navigation based output signals and other features that save time and money during installation.
Combines OS-4 & SWI-RC Interface
- Retains steering wheel controls (pre-programmed)
- Retains OnStarĀ® when the factory radio is replaced
- Retains factory Bluetooth (2009+ model vehicles)
- Retains rear seat audio controls
- Retains all warning chimes (chime module included)
- Retains back-up sensors/park assist
- Retains factory Bose audio systems
- Retains factory premium Bose audio (Y91 digital. does not support fading)
- Retains factory reverse camera
- Dual zone function
- Chime volume adjustment (factory buttons)
- Rear seat audio and video (GMRVD2) required
- OnStar volume adjust from steering wheel controls
- OnStar volume adjustment
- Retained accessory power output (RAP)
- Reverse wire output
- VSS (Vehicle Speed Sense) output
- Illumination output
- Parking brake output
- Includes antenna adaptor
- Retains lane departure warning system
- Retains OnStar Turn-by-Turn voice prompts
- Updatable using the PAC-UP
Compatibility Notes:
> Does not retain factory satellite radio
For use in the following vehicles:
> All 2012-2013 GM trucks and SUVs equipped with factory navigation radios
> 2012+ 2500 & 3500 trucks equipped with factory navigation radios
> 2012-2013 GM trucks & SUVs equipped with factory non-navigation radios must use the RP5-GM31
> 2012+ 2500 & 3500 trucks equipped with factory non-navigation radios must use the RP5-GM31
> 2014+ Silverado & Sierra 1500 series trucks must use the RP5-GM51
In Premium Amplified Systems there will be no fading capability of the aftermarket stereo
Does not retain factory XM tuner. This is built into the factory radio and is removed when the radio is removed.
Sony Bluetooth SWC commands are only supported with revision 1.6.6.14 or higher