Victron Blue Smart IP67 Charger 12/7(1) 120V NEMA 5-15
120V AC / 12V DC / 7 Amp
Bluetooth Smart enabled
IP67 Waterproof
Input voltage range and frequency: 100-135 VAC 45-65 Hz
Efficiency: 93%
Charge current: 7A (High)
Charge current: 2A (Low)
No load power consumption: 0.5W
Charge voltage ‘absorption’ Normal: 14.4V / High: 14.7V / Li-ion: 14.2V
Charge voltage ‘float’ Normal: 13.8V / High: 13.8V / Li-ion: 13.5V
Charge voltage ‘storage’ Normal: 13.2V / High: 13.2V / Li-ion: 13.5V
Charge algorithm 5-stage adaptive
Protection Battery reverse polarity (fuse)
Output short circuit Over temperature
Dimensions: 3.4″ x 8.3″ x 2.4″
The Blue Smart IP67 Charger is the wireless solution to monitor voltage and current, to change settings and to update the charger when new features become available.
Completely encapsulated: waterproof, shockproof and ignition protected, Water, oil or dirt will not damage the Blue Smart IP67 Charger. The casing is made of cast aluminum and the electronics are molded in resin.
The highest efficiency ever!
Setting a new industry standard: with 93% efficiency or better, these chargers waste three to four times less heat.
And once the battery is fully charged, power consumption reduces to less than a Watt, some five to ten times better than the industry standard.
Adaptive 5-stage charge algorithm: bulk – absorption – recondition – float – storage
The Blue Smart Charger features a microprocessor controlled ‘adaptive’ battery management. The ‘adaptive’ feature will automatically optimism the charging process relative to the way the battery is being used.
Storage Mode: Less maintenance and aging when the battery is not in use
The storage mode kicks in whenever the battery has not been subjected to discharge during 24 hours. In the storage mode float voltage is reduced to 2.2 V/cell (13.2 V for a 12 V battery) to minimize gassing and corrosion of the positive plates. Once a week the voltage is raised back to the absorption level to ‘equalize’ the battery. This feature prevents stratification of the electrolyte and sulphation, a major cause of early battery failure.
Also charges Li-ion batteries
Li-ion batteries are charged with a simple bulk – absorption – float algorithm.
Fully discharged battery recovery function
Will initiate charging even if the battery has been discharged to zero volts.
Will reconnect to a fully discharged Li-ion battery with internal disconnect function.
Protected against overheating
Can be used in a hot environment such as a machine room. Output current will reduce as temperature increases up to 60°C, but the charger will not fail.
Two LEDs for status indication
Yellow LED: bulk charge (blinking fast), absorption (blinking slow), float (solid), storage (off) Green LED: power on