Victron BlueSolar MPPT 250V / 100A – Tr Charge Controller with Bluetooth & VE.Can Interface
Battery voltage: 12 / 24 / 48V DC (Auto) 36V DC Manual
Rated Charge Current: 100 Amp
Nominal PV power, 12V DC: 1450 Watts
Nominal PV power, 24V DC: 2900 Watts
Nominal PV power, 36V DC: 4350 Watts
Nominal PV power, 48V DC: 5800 Watts
Maximum PV open circuit voltage: 250V
Maximum efficiency: 99%
Charge voltage ‘absorption’: Default setting: 14.4 / 28.8 / 43.2 / 57.6 V (adjustable)
Charge voltage ‘float’: Default setting: 13.8 / 27.6 / 41.4 / 55.2 V (adjustable)
Charge voltage ‘equalization’: Default setting: 16.2 V / 32.4 V / 48.6 V / 64.8 V (adjustable)
Charge algorithm: multi-stage adaptive (8 pre-programmed algorithms) or user defined algorithm
Protection: PV reverse polarity / Output short circuit / Over temperature
Operating temperature: -22° to 140°F – Full Rated Power up to 100°F
Data communication: VE.Can, VE.Direct and Bluetooth
Dimension (H x W x D): 8.5″ x 4″ x 11.6″
Solar charge controller
The MPPT VE.Can SmartSolar charger uses the latest and fastest technology to convert energy from a solar array into energy that optimally charges a battery banks. The SmartSolar charge controller will even recharge a severely depleted battery. It can operate with a battery voltage as low as 0 Volts, provided the cells are not permanently sulphated or otherwise damaged.
MPPT: Ultra Fast Maximum Power Point Tracking
The MPPT VE.Can SmartSolar charger connects to a PV array of 150 or 250 Volt Voc and will automatically detect and charge your 12, 24, or 48V battery bank with current 100Amp. The charge settings are fully programmable and can even be set up for different battery chemistries, like lead-acid, lithium and others.
Control Your Charger Remotely – Bluetooth
The MPPT VE.Can SmartSolar charger can be remotely controlled and configured over Bluetooth via the VictronConnect App. This allows device set-up, management, and at-a-glance information, such as battery voltage and current, PV voltage and current, and historical data.
Daisy Chain Additional Units
The VE.Can SmartSolar charger is equipped with CAN bus ports. This allows for communication with additional VE.Can SmartSolar chargers. The additional units are simply “daisy chained” to each other with a single RJ45 cable between the individual units. When connected to each other, all individual VE.Can SmartSolar chargers, will synchronize their charge stages. They can also send their data, via a single cable, to a GX monitoring device.
Remote Monitoring and Control
If the GX device is connected to the internet, the Victron Remote Management Portal (VRM) provides access to the full power of your solar charger(s).
The VE.Can SmartSolar charger is also equipped with a VE.Direct port. This port can be for single unit monitoring or for streetlight control. The remote on/off connector can be externally controlled by a third-party device like a lithium battery.
An optional plug-in LCD display/control provides live-data, set-up and management, straight from the face of the device.