89 Piece Professional Gunsmithing Screwdriver Set
Screwdrivers are the most important and most-used gunsmithing tools.
Wheeler’s® Deluxe Gunsmithing Screwdriver Set is the kit that belongs on every gunsmithing bench – the well thought-out bit selection will put an end to burred, buggered, busted up screw slots on any gun that comes your way. The bits make up the heart of any screwdriver set, and Wheeler’s are the finest available. They’re made from S2 tool steel and hardened to 56-58 Rockwell “C.” Unlike other screwdriver suppliers,Wheeler’s engineers measured the screws on over one hundred modern and antique firearms to make sure that we offered bits for every situation.
Keep your gun looking and operating as good as new!
Avoid costly damage that ruins the look and value of your guns!
Whether you’re working on a Browning Superposed, a Remington 700, a Smith & Wesson® revolver, or a Colt Single Action, you’ll find that there’s a bit to fit every screw on your gun. The 54 Hollow-ground flat bits range in size from .120″x.020″ to .360″x.070″, and includes doubles in the thinnest sizes. (Any gunsmith will tell you that you’re occasionally going to break the ultra-thin bits on stubborn screws. This set includes two each of the very thinnest bits, which means you’ll never be stuck in the middle of a job without the proper bit. Replacement bits are available in three packs for a very modest price.)
The set also includes a complete selection of Phillips, Allen, and Torx bits to cover scope rings, bases, recoil pads, and the like. The difference in the “basic set” and the “professional set” lies in the 15 ingenious “specialty bits” that are included in the “professional” set. These 15 pieces include all of the bits pictured below. These bits are great for installing scope bases, getting you out of a pinch by providing a small pin punch when you really need it, and keeping once-in-a-while lifesaver tools at your fingertips.
Both sets come with two handles made from comfortable overmolded plastic. The first is a regular size handle that’s good for most jobs, and the second is a slimmer, shorter “Close Quarters” handle that is good for finesse work with smaller bits.
Both sets also come in a durable custom box that’s ready for the bench or your range kit.
Case Size: 8″x12″x3″
Bit Material: S2 Tool Steel
Bit Hardness: 56-58 Rockwell C
Driver Handles: 2, with magnets
Extension: 1, 3? with magnet
Adapter: 1 Hex to square drive
Flat Bits: 54 Hollow-Ground
Allen Bits: 8
Phillips Bits: 4
Torx Bits: 3
Specialty Bits: 15